Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
If the LED rope light
any length of time (e.g. holidays), disconnect
it from the power supply.
Keep away from ponds and other water reservoirs.
Install the LED rope light
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The LED rope light
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light
it is laid down properly so that no one walks or
trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The LED rope light
normally inflammable surfaces with the enclosed
mounting parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or water
lines located where you wish to drill. Check with
a cable and pipe locator if necessary before
you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the LED rope light
consult an electrical specialist for advice.
Do not use sharp and / or pointed objects such
as wire, nails or fasteners for mounting.
Do not attach any additional objects to the
LED rope light
.
1
Avoid excessive bending of the LED rope
light
. This can damage the insulation.
1
6
GB/IE/NI
is not to be used for
1
at least 2 metres
1
outdoors, make
1
is protected against
1
is not laid
1
and make sure
1
can be installed on all
1
. If you are in any doubt,
1
The bending radius of the rope must not fall
below the following value: rope diameter
between 10–14 mm: 2 cm.
Avoid excessive heating of the LED rope light
A maximum of two sections of rope may cross
or run parallel to each other.
Installation
Note: Remove all packaging materials from the
product before use.
First, please unroll the product before use.
Note: The LED rope light
all surfaces officially classified as being of "normal
flammability" by means of the supplied attachments.
Please fix the LED rope light
surface and fix the product by attaching it with
the help of the included cable ties
Alternatively, you can also mount the product
by using the included attachment clips
place the attachment clips
face and fix them with the included screws
by using a crosshead screwdriver. Once the re-
quired attachment clips
you can press LED rope light
ing of attachment clips
the cable tie
to secure the LED rope light
3
onto the attachment clips
Use
Plug the mains plug into the socket.
The lighting is switched on.
To turn the lighting off, remove the mains plug
from the socket.
Timer function
To switch on the timer function, press the timer
button
after the product is connected to the
5
socket of power supply. The timer button
will light up when the timer function is activated.
The product lights glow permanently for 6 hours
and will be followed by a subsequent pause of
1
can be mounted on
1
on the desired
1
.
3
. Firstly,
2
in a sturdy sur-
2
4
have been attached,
2
into the open-
1
. You may further use
2
1
if need.
2
5
.
Advertenties
Hoofdstukken
Inhoudsopgave
