Advertenties
Beschikbare talen
Beschikbare talen
Extra paper filter
An extra paper filter (dust bag) is supplied with the device. You are advised to replace the
HEPA filter with this filter if you intend to clean very fine particles, e.g. in the event of
drilling or sanding work. This will prevent you from having to clean the HEPA filter during
this type of work. Install the paper dust bag as follows:
• Remove the HEPA filter
(see: Cleaning the filter)
• Remove the 'knee' on the
air inlet within the drum
• Slide the opening in the
paper dust bag over the
air intake opening
• Secure the cover (without
HEPA filter, secure with
clamps)
To clean up
Switch the device off and remove the plug from the socket.
Wind the electrical cable around the cable hanger; the upper
section provides a groove into which you can wedge the plug.
Place the accessories at the appropriate locations behind the
device, see image.
Cleaning and maintenance
Before cleaning or maintenance: always switch off the equipment and unplug it.
Filter cleaning system
When you feel that the suction is getting
weaker, please remove the tube and jam
the hose by hand (while the equipment is
working). Then press the filter cleaning
button 10-15 times: this will clean the
filter and recover the suction force.
Emptying barrel
Open both the locking blocks (4) en take the up
housing from the vacuum cleaner. Remove the
dust out of the barrel and clean the barrel if
necessary. At the end, place back the up housing
and close the locking blocks.
14
Advertenties
