Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installing
SGD7S-OSB02A
M SGD7S-OSB02A
N Mounting screws for safety
module
O Preassembled mounting screw
Mounting the Module
Cover
E Module cover
P Wire cutter
Q Joints
YASKAWA EUROPE TOMP YEUOS7S 01A – Sigma-7 Series Advanced Safety Module – Instruction Manual
1. Hold both ends of the safety module (J) and firmly insert the board
connector into the connector port on the SERVOPACK.
2. Attach the safety module to the SERVOPACK with three screws (K and L)
(tightening torque: 0.49 Nm).
M
1. Hold both ends of the safety module (M) and firmly insert the board
connector into the connector port on the SERVOPACK.
2. Attach the safety module to the SERVOPACK with three screws (N and O)
(tightening torque: 0.49 Nm).
E
P
Q
1. Cut off the four joints (Q) with a wire cutter (P) and remove the front cover
(shown in the illustration) from the module cover (E).
Cutting out the module cover is only required for SGD7S-OSB02A.
O
N
Q
19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
