Inhoudsopgave
Advertenties
To guarantee the function of the splitting wedge, its distance
from the toothed wheel its distance from the teeth of the saw
blade above the table must not be more than 5 mm.
Adjusting the blade guard
Set the cutting height
The cut height
can be adjusted
stepless
from
0 - 73 mm
using the crank
(6).
Before setting
the cut height,
tighten the set
screw for the
saw blade (15).
Set the cutting
height 5 mm
higher than the
material
thickness.
Adjust saw blade pitch
The saw blade must not be set to the inclined position
when the blade is turning. The motor must be switched off
first.
Adjusting between 0° - 45°
1. Loosen
the
clamping
screw (15).
2. Turn
the
adjusting knob
(14) until your
desired angle
is indicated (0°
- 45°).
3. Retighten the
clamping
screw (15).
Adjusting the angle indicator:
1. Turn the machine off and unplug the power cord.
2. Use an angle stop to align the saw blade vertically.
3. Loosen the screw (A) and slide the angle indicator to the 0°
mark.
22
All manuals and user guides at all-guides.com
p. 88, figure Q5 / Q6.
Fitting and adjusting the transverse
stop
The transverse stop supplied can be used as a
transverse or mitre stop.
Setting the angle. Loosen the clamping screw of the
transverse stop by turning.
Fit the transverse stop to the saw table plate
Push the transverse stop (11) into one of the two
grooves on the saw table plate.
Setting the angle
Loosen the clamping screw (B) of the transverse stop
by turning. You can now set the stop to the required
angle. Turn the clamping screw tight again.
Advertenties
Hoofdstukken
Inhoudsopgave
