Turning on the Appliance
Place the unit securely on a firm surface.
Caution
The appliance must not be carried during cleaning.
Insert the mains plug into a socket.
Both indicator lamps must illuminate.
Caution
Do not turn the appliance on without water in the
boiler. Otherwise, the appliance may overheat
(see Help with faults).
The orange indicator lamp goes out after ap-
proximately 8 minutes.
The steam cleaner is ready to use.
Adjusting the Steam Quantity
Use the selector switch for the steam volume to
regulate the discharged steam. The selector
switch has three positions:
Maximum steam volume
Reduced steam volume
No steam - child protection
Note: In this lever position, the steam le-
ver cannot be used.
Set selector switch to the required steam volume.
While operating the steam switch, always di-
rect the steam gun at a separate piece of
cloth until the steam is emitted evenly.
Note: The heating of the steam cleaner is
turned on in regular intervals during the op-
eration of the appliance in order to maintain
the pressure in the boiler at a constant level.
When the heating is turned on, the orange
indicator lamp (heater) lights up.
Refilling Water
Water needs to be filled into the boiler, if the
steam volume decreases during work and no
more steam is emitted in the end.
Note: The safety lock cannot be opened as long
as slight pressure remains in the boiler.
Push the steam switch until steam discharge
stops. Now, the boiler of the appliance is un-
pressurized.
Disconnect the mains plug from the socket.
Remove the safety cap from the device.
Danger
A residual amount of steam may be emitted when
you open the safety lock. Be careful when opening
the safety lock, there is a risk of scalding.
Fill the boiler with a maximum of 1 liters of
fresh tap water.
Danger
If the boiler is hot, there is the risk of scalding as
the water may splash back during the filling proc-
ess! Do not fill any detergents or other additives
into the boiler!
Screw the safety cap back onto the device.
Insert the mains plug into a socket.
The orange indicator lamp goes out after ap-
proximately 8 minutes.
The steam cleaner is ready to use.
Turning Off the Appliance
Disconnect the mains plug from the socket.
Press the cover of the appliance connector
to the bottom and disconnect the steam plug
from the appliance connector.
Storing the Appliance
Illustration
–
Put the extension pipes into the large aces-
sory compartments.
–
Insert the manual nozzle and detail nozzle
onto each extension pipe.
–
Put the round brush into the medium acesso-
ry compartments.
–
Hook the floor nozzle into the parking position.
–
Wrap the steam hose around the extension
pipes and insert the steam pistol into the
floor nozzle.
How to Use the Accessories
Important application instructions
Cleaning of Textiles
Prior to treatment with the steam cleaner, always
check the reaction of the textiles in an inconspic-
uous location: Steam heavily at first, then let dry
and then check for colour or shape changes.
Cleaning of Coated or Lacquered Surfaces
Be careful when you clean kitchen and living
room furniture, doors, parquet, lacquered or
plastic-coated surfaces. The wax, furniture
polish, plastic surfaces or paint can come loose
or stains can be created. Therefore, always
clean these surfaces with a steamed cloth only.
Caution
Never direct the steam jet at glued edges as the
edge band may loosen. Do not use the steam
cleaner on unsealed wooden or parquet floors.
– 8
EN
15