Inhoudsopgave
Advertenties
II. General function
This energy-saving controller for radiators can be used to
control room temperature on the basis of time. The actuator moves
a valve, thereby allowing the amount of heat flowing to the heat-
ing appliance to be controlled. The controller is compatible with all
standard heating appliance valves.
Installation can be achieved in 3 easy steps.
Step 1: Inserting (replacing) the batteries
• Remove the battery com-
partment cover.
• Insert 2 new LR6 batter-
ies (Mignon / AA) into the
battery compartment, en-
suring they are the right
way round.
• Reattach the battery com-
partment cover and click
into place.
New alkaline batteries have a life of approximately 3 years.
A battery symbol (
) will indicate when the batteries
need to be replaced. After removing the old batteries,
please wait approximately 1 minute before inserting the
new ones. This device does not support operation with
rechargeable batteries.
Never recharge standard batteries.
Doing so will present a risk of explosion.
Do not throw the batteries into a fire.
Do not short-circuit batteries.
Used batteries should not be disposed
of with regular domestic waste. Instead,
they should be taken to your local battery
disposal point.
20
Step 2: Setting the date and time of day
The firmware version number will be displayed briefly once
you have inserted/replaced the batteries and then you will
be automatically prompted to set the date and time of day.
• Use the setting wheel (B) to set
the year (A).
• Confirm with OK (C).
• Use the setting wheel (B) to set
the month (A).
• Confirm with OK (C).
• Use the setting wheel (B) to set
the day (A).
• Confirm with OK (C).
• Use the setting wheel (B) to set
the hour (A).
• Confirm with OK (C).
• Use the setting wheel (B) to set
the minute (A).
• Confirm with OK (C).
The motor will start moving back the control pin while the
entries are still being made.
• If "INS" is displayed with a rotating "∏" symbol, this
indicates that the motor is still moving back. Once the
device is ready for the actuator to be installed on the
valve, just "INS" will appear on the display.
• The weekly program and other settings can be cus-
tomised prior to installation. To do this, press the menu
button when "INS" is shown on the display. For further
details, please see "4. Configuration menu".
• Once programming is complete, "INS" will reappear on the
display and installation (Step 3) can commence.
A
B
C
21
Advertenties
Hoofdstukken
Inhoudsopgave
