Advertenties
The weight window does not display "
3.3.2.8. TURNING OFF THE SCALE
Please press the key [
3.3.2.9. COUNTING PIECES
1. Place the products on the weighing pan, and press the "
2. Enter the number of product pieces on the scale with the numeric keypad.
3. Press the "
" button again to confirm.
3.3.3. BATTERY CHARGING
Please charge the storage battery in time after using it to avoid damage. The charging time should not be longer
than 12 hours, once every three days. If the scale will be not used for a long time, please do not forget to charge
the scale for consecutive 24 hours every 2 or 3 months to avoid damage caused by self-discharge of storage
battery (when the scale is connected to AC power, the system will charge the storage battery automatically
whether the scale is turned on or off. It is advised to charge the electronic scale after it is turned off).
3.3.4. CALIBRATION METHOD
1. Switch on the balance.
2. After an automatic check, the display shows "
3. Enter the code "
4. Press the "
" button, press the "
(UNIT PRICE).
5. Press the "
" button again: " " will appear in the total price window (TOTAL), "
the single price window and "
of 15 kg on the scale.
6. Press the "
" button, at this moment the total price and unit price displays will show "
calibration is finished.
USE GUIDELINES
•
Do NOT leave a load on the scale for long periods of time.
Avoid extreme temperatures. Do not place the unit in direct sunlight or near air conditioning units.
•
Avoid using strong electrical or magnetic fields during use.
•
Avoid vibration. Do not place the device near heavy or vibrating machinery.
•
Do not place the unit close to open windows, doors, or fans that may cause unstable results due to air
•
currents.
Keep your machine clean. Do not store products on the scale when it is not being used.
•
Avoid any strong shock or heavy weight. Don't put any article or give pressure over maximum capacity
•
on the scale pan even the scale is not in use.
•
Wrong wire connection of storage battery is forbidden. Right connection: Red wire should be connected
with the red end; Black wire should be connected with the black end.
" when unloaded, please press key [
] and then pull the power plug out.
" or "
" and press the "
" button again until "
" will appear in the weight window (WEIGHT). Put a weight / weights
EN
" button.
".
" button to enter the calibration mode.
" appears in the unit price window
] (within the range of ±60d).
" will appear in
". The
Advertenties
