Inhoudsopgave
Advertenties
FASTENING THE HOIST TO THE LOAD
1
Altach the Ioad hook 10, which is fas-
tened to the wire cable
8
by the guide
roller
9
, securely to the Ioad you intend
to pull. Check that the snap lock
closed.
3
By holding the stop lever
5
in the re-
leased position, the cable can be un-
wound and the hoist can be pulled.
PULLING A LOAD
1
Push the tensioning spring
2
down and
into the pull position, which engages
the retaining catch
3
in the pulley
again.
Warning! Only pull loads horizon-
tally.
SLACKENING/RELEASING THE HOIST
1
Make sure that the load is fastened
securely to prevent it being released
unintentionally. To release the hoist,
push the tensioning spring
2
upwards
to release the retaining catch 3.
Warning! lt is possible for the load
to be re leased abruptly!
3
Hold the stop lever
5
in this position
with your finger and release the clamp-
ing lever
1
again.
88
EN
2
Push the tensioning spring
into the release position, which re-
leases the retaining catch
3
6
is
pulley 4.
4
Pull the hoist to the second attachment
point and attach with the fastening
hook 7.
2
Now move the hand lever
pumping movements. This rewinds the
4
wire cable
8
onto the pulley
4
pulls the load to the desi red position.
2
Push the clamping lever
1
completely, the stop lever
5
upward.
4
Releasing the clamping lever
ens the wire cable 8. You can now re-
lease the load hook
10
and the fasten-
ing hook
7
and remove the wire rope
puller.
2
up and
1
from the
3
2.
2.
1
using
1
again and
forward
1
is pushed
1
slack-
3
2
4
1. 1.
2
2
2. 2.
4
1. 1.
EN
89
Advertenties
Hoofdstukken
Inhoudsopgave
