Inhoudsopgave
Advertenties
Safety Instructions
WARNING Read all safety warnings,
instructions, illustrations and speci-
fications provided with this power tool.
Failure to follow the warnings and instructions
may result in serious injury.
Save all warnings and instructions for fu-
ture reference.
Warning: The lifting of loads is strictly
prohibited!
Warning: The equipment may only be
used for pulling loads horizontally.
Warning: There is a risk of crush inju-
ries to fingers!
Warning! The equipment and packag-
ing material are not toys. Do not let
children play with plastic bags, foils or small
parts. There is a danger of swallowing or suf-
focating!
1. Wear protective clothing which is suit-
able for the particular environment for the
whole time while carrying out your work
and take safety precautions appropriate
for the particular en vironment to prevent
accidents.
2. Wear protective gloves at all times while
working with the equipment.
3. The equipment is only allowed to be
opera ted by persons who have carefully
read and understood these instructions;
the equipment is not allowed to be op-
erated by persons who have not been
given appropriate instruction or who have
health issues.
4. The equipment is only allowed to be oper-
ated by a single person. No other persons
are allo wed to be within the work area.
5. Only proceed to move a load after ensur-
ing that the load is fixed securely to the
hook and there are no persons in the dan-
ger zone.
84
EN
6. Never allow children to come anywhere
near the equipment.
7. Observe every movement of the load and
the equipment while working with it.
8. The weight is not allowed to exceed the
maximum load capacity speci fied by the
manufacturer in the technical data and
on the identification plate of the wire
rope puller. Exceeding the maximum load
capacity could result in damage to the
equipment and inju ries.
9. Take care at all times to make sure that
you never allow any parts of your body
such as, e.g. fingers, to get into rotating
parts or parts under tension.
10. Before starting the work you intend to
carry out, always check the equipment
each time to ensure that all its compo-
nents are in perfect working order. In par-
ticular, check that all screw connections
are secure and that the carabiner hooks
are in perfect condition, to prevent the
unintended release of the hook.
11. Never use the equipment if it is defective
or damaged. lf the cable has any frac-
tures or is damaged in any other way, it
must be repla ced. In this case, immedi-
ately contact the ma nufacturer or arrange
for the equipment to be checked and re-
paired by a qualified expert.
12. Always exercise care and due caution
while working. Do not apply excessive
force.
13. Operate the hand lever smoothly to avoid
ab rupt jolts or tangling.
14. Do not increase the leverage effect of the
hand lever by using an extension tube or
other aid.
15. Look out for any defects occurring during
use. In the event of any anomalies during
use, stop using the equipment immedi-
ately.
16. Never use the equipment as a pulley
block or similar.
17. Never use any electrical devices to oper-
ate the equipment. This equipment is de-
signed for manual operation only.
18. Never wind the cable around an object
like a loop in order to hang the hook in the
cable. Never run the cable around corners
and ne ver draw it over edges.
19. Make sure to leave three remaining wind-
ings of wire cable secured by rivet on the
pulley under load at least.
20. Never use the equipment as a tow rope.
21. Store the equipment only in a dry room.
22. Never use the equipment in an explosive
en vironment or in damp locations.
23. The ambient temperature for operation
must be between -10°C and +50°C.
24. Do not use this equipment for industrial
use.
25. Please use an adequate sling, eyebolt or
other accessory attached to the load to
be pulled. Make sure that there is posi-
tive engagement of the puller hook to the
load.
26. Not for operating on a slope surface! For
horizontal pulling only! Moving of loads on
inclined planes and lifting of loads is not
permitted.
Intended use
The wire rope puller is a device for moving loads
horizontally.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Technical data
Max. tensile load
1000 daN
Cable diameter
ø 5.0 mm
Max. effective distance
1200 mm
Weight
2.28 kg
EN
85
Advertenties
Hoofdstukken
Inhoudsopgave
