Inhoudsopgave
Advertenties
Trouble or fault
Product does not develop full
power.
Drill bit does not rotate.
The insert tool cannot be re-
leased from the chuck.
Product does not start.
Service indicator shows.
Service indicator flashes.
The ON/OFF indicator flash-
es.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
Further information
For more information on operation,
qr.hilti.com/manual/?id=2267486&id=2267488
This link is also to be found at the end of the documentation, in the form of a QR code.
*2267486*
Possible cause
The control switch is not fully
pressed.
The half-power button is engaged.
The function selector switch is not
engaged or is in the "Chiseling"
position
or the "Chisel position-
ing" position
.
Tool holder not pulled back fully.
The side handle is not fitted cor-
rectly.
The electronic restart interlock is
activated after an interruption in
the electric supply.
Service limit time reached.
The product is faulty.
Product momentarily overloaded.
Protection against overheating.
technology,
2267486
Action to be taken
▶ Press the control switch as far
as it will go.
▶ Press the "half-power" button.
▶ With the motor at a standstill,
set the function selector switch
to the "Hammer drilling"
position.
▶ Pull the tool lock back as far
as it will go and remove the
accessory tool.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
▶ Switch the product off and then
on again.
▶ Have the product repaired by
Hilti Service.
▶ Have the product repaired by
Hilti Service.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down
and clean the air vents.
environment and recycling,
follow this link:
English
29
Advertenties
Inhoudsopgave
