Inhoudsopgave
Advertenties
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Liion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
No hammering action.
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
No response from the LEDs
on the battery.
The drive spindle doesn't
rotate.
Product switches off auto-
matically.
Product switches off if drill bit
jams.
Product or battery gets very
hot.
No response from the LEDs
on the battery.
28
English
Possible cause
The product is too cold.
Battery condition is not optimal.
The retaining lugs on the battery
are dirty.
Battery defective.
The permissible operating temper-
ature of the product's electronics
has been exceeded.
The battery is not fully inserted.
The overload protection system is
active.
The electronic safety shut-down
has tripped to prevent further jam-
ming.
Electrical fault.
The product is overloaded (appli-
cation limit exceeded).
Battery defective.
Action to be taken
▶ Bring the product into contact
with the working surface, switch
it on and allow it to idle. If
necessary, repeat the procedure
until the hammering mechanism
begins to operate.
▶ Call up the battery's state of
health. Section headed "Status
indicators of the Liion battery"
22.
▶ Clean the retaining lug and refit
the battery.
▶ Contact Hilti Service.
The ON/OFF indicator flashes.
▶ Allow the product to cool down.
▶ Push the battery in until it
engages with an audible click.
The ON/OFF indicator flashes.
▶ Release the control switch.
Allow the product to cool down.
Press the control switch again.
Reduce the load on the tool.
▶ Release the drill bit.
▶ Immediately switch off the
product. Remove the battery
and keep it under observation.
Allow it to cool down. Contact
Hilti service.
▶ Select a product that is suitable
for the intended purpose.
▶ Contact Hilti Service.
2267486
*2267486*
Advertenties
Inhoudsopgave
