To clean the product
•
Clean plastic parts with a clean and dry cloth.
•
Do not use water to clean the product. Water can
enter the battery or the motor and cause short circuit
or damage to the product.
•
Do not use a high pressure washer to clean the
product.
•
Do not flush water directly on the motor.
•
Use a brush to remove leaves, grass and dirt.
To clean the battery and the battery
charger
WARNING:
the battery charger with water.
WARNING:
substances to clean the battery.
•
Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
•
Clean the battery terminals with compressed air or
use a soft and dry cloth.
•
Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To examine the dethatcher equipment
WARNING:
turn the safety key to 0, remove the battery
and wait at minimum 5 seconds.
Battery
LED on the battery
The green LED flashes.
The battery error LED
flashes.
The battery error LED
comes on.
16
Do not clean the battery or
Do not use any chemical
To prevent accidental start,
Troubleshooting
Cause
The battery voltage is
low.
The battery is too cold
or too hot to use.
The battery is empty.
There is a permanent
battery error.
WARNING:
when you do maintenance on the dethatcher
equipment. The tines on the dethatcher
equipment are very sharp and cuts can
easily occur.
•
Examine the dethatcher equipment for damage
or cracks. Always replace a damaged dethatcher
equipment.
To replace the dethatcher equipment
WARNING:
when you do maintenance on the dethatcher
equipment. The dethatcher equipment is
very sharp and cuts can easily occur
1. Put the product on its right side. (Fig. 40)
2. Remove the 2 screws (A) and the dethatcher cover
(B). Push the dethatcher equipment (C) up and out
to remove it. (Fig. 41)
3. Push the new dethatcher equipment (C) into the
groove and down the hole. Attach the dethatcher
cover (B) and the 2 screws (A) (Fig. 42)
Solution
Charge the battery. Refer to
Let the battery cool down or move it indoors to warm it up.
When the battery has the correct temperature, it can be used
again. Use the battery in the product only when the ambient
temperature is 5 °C–40 °C.
Charge the battery. Refer to
Speak to your Husqvarna servicing dealer.
Use protective gloves
Use protective gloves
To charge the battery on page 14 .
To charge the battery on page 14 .
937 - 009 - 27.09.2024