Inhoudsopgave
Advertenties
Features
This tool includes some or all of the following features.
1. On/Off button
2. Handle
3. Handle reset button
4. Nozzle
5. Charging indicator
6. Dust collector cover
7. Cover release button
8. Charging base
9. Accessory caddy
10. Crevice tool
11. Brush tool
Assembly
Accessories (fig. A & B)
These models may be supplied with some of the following
accessories:
An accessory caddy for storing your accessories.
u
A crevice tool (10) for confined spaces.
u
Brush tool (11) for furniture and stairs.
u
Fitting the accessory caddy (Fig. A)
Place the edge of the charger base (8) on to the edge
u
of the accessory caddy (9).
Insert the brush tool (11) into the front of the crevice
u
tool (10) then push the crevice tool into the accessory
caddy.
(Original instructions)
Fitting the accessories (Fig. B)
Lift the handle (2) until it clicks into place. The nozzle
u
(4) will automatically lift at the same time.
Insert the crevice tool (10) into the front of the nozzle
u
(4). Make sure that it is pushed fully in. If the brush
tool (11) is required then insert the brush tool (11) onto
the front of the crevice tool (10).
Use
Before first use, the battery must be charged for at
u
least 24 hours.
Place the appliance on the charging base whenever it
u
is not in use.
Charging the battery (Fig. C)
Place the appliance on the charging base (8)
u
Plug in the charger. Switch on at the mains. The
u
charging indicator (5) will be lit.
Leave the appliance to charge for at least 16 hours.
u
While charging, the charger may become warm. This is
normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely. The
charging indicator (5) will be lit as long as the appliance is
connected to the plugged-in charger.
Warning! Do not charge the battery at ambient tempera-
tures below 10 °C or above 40 °C.
To open the appliance (fig. D)
Lift the handle (2) until it clicks into place.
u
The nozzle (4) will automatically lift at the same time.
ENGLISH
7
Advertenties
Inhoudsopgave
