Inhoudsopgave
Advertenties
Set cut height
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
Switch off the motor and remove the contact key.
M
1. Pull the lever out
.
2. Set the desired cutting height
M
3. Press the lever back in
.
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not se cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 40 mm.
Starting and Stoping
Switch on motor with mowerplaced on level and firm ground.
not in high grass - alternatively tilt slightly
Switch-on motor
S
1. Depress button and hold (1).
2. Lift up bar (2).
3. Release button (1).
Maintenance
General
1
Caution! Rotating blade
Before carrying out any maintenance or cleaning work:
Remove the contact key.
Remove the battery.
Do not touch rotating blades.
Cleaning
Clean mower thoroughly after each mowing with cloth or
brush.
Never spray the mower with water.
Winter Storage
Clean mower thoroughly before storing away.
Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
Do not store it in a wet or humid place.
The Lithium iron battery must also be recharged before pro-
longed periods of non-use, for example at the beginning of
winter.
16
All manuals and user guides at all-guides.com
N O
.
R
.
Switch-off motor
S
Release bar (2).
3
Tip for mowing:
To prevent strips of grass from being left unmowed, the cut-
ting paths must always overlap a few centimeters
Overload protection
3
In case of overload or blocking, the motor shuts down
automatically!
Switch off the motor and remove the contact key.
Overload: Cutting height is too low, or forward speed is
too fast
Blocking: Foreign object in cutting area (e.g. branches)
The machine can be switched on again after about 5
min.
Emptying of Grassbox
Q
When the collection bag is full, the flap lowers by itself.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Switch off the motor and remove the contact key.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Blade change
U
1
Caution! Rotating blade
Before carrying out any maintenance or cleaning work:
Remove the contact key.
Remove the battery.
Do not touch rotating blades.
Wear protective gloves.
1
Attention!
An unbalance can develop after regrinding of the blade.
Always regrind the blades in a specialist workshop, be-
cause an unbalance check should be undertaken accor-
ding to the safety regulations.
Always change blades in a specialist workshop. A torque
spanner of 10 mm is mandatorily required.
Fastening torque of the screws: 6 - 7 N-m .
Use only original WOLF spare parts.
T
G
Advertenties
Hoofdstukken
Inhoudsopgave
