Inhoudsopgave
Advertenties
ENGLISH
5) DMX512 MODE:
The laser can be controlled by any standard DMX-controller in 2 different DMX-modes:
1 CHANNEL MODE: for extremely easy setup and use! (display shows <1Ch=)
8 CHANNEL MODE: for full control on every functionalities. (display shows <17c=)
Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the
DMX-output of your controller.
Press the FUNC-button until the display shows: <1Ch= or <8Ch=.
Press the UP/DOWN buttons to select the DMX-mode. (1ch or 8ch)
Press the ENTER-button to confirm your choice.
Press the FUNC-button: the 3 digit number on the display starts blinking.
Select the DMX-address
Press the ENTER-button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to <daisy chain= your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of the
light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the end of
the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
1 CHANNEL DMX-CONFIGURATION OF THE LASER:
DMX-value
150-255
030-149
000-029
8 CHANNEL DMX-CONFIGURATION OF THE LASER:
IMPORTANT REMARK: DMX Channel1 is used to set the different working modes of the laser.
To use the laser in full 8 channel mode, channel 1 must be set to value 192 or higher.
Depending on the DMX-values of channel1, different mode can be applied:
®
JB SYSTEMS
FIXED
PATTERN
PATTERN
Last pattern and current pattern cycle repeating
REPEAT
function
SOU
Sound activated show
AUT
Automatic show
STANDBY
Laser output off
You can select one pattern from 1 to 48
remarks
7/54
USER MANUAL
SPACE-4 LASER
Advertenties
Inhoudsopgave
