Inhoudsopgave
Advertenties
ENGLISH
HOW TO SET UP AND CONTROL THE UNIT
MUSIC INPUT SENSITIVITY:
The unit works to rhythm of the beat when used in standalone or master/slave mode
To set the input sensitivity, follow these steps:
Press the FUNC-button until the display shows <S 0= ...=S 9=
Press the ENTER-button to confirm your choice.
Use DOWN and UP button to select a value between <S 0= (very low sensitivity) and <S 9= (high
sensitivity).
Once the mode is selected, press the ENTER button save it.
You can operate the unit in 5 ways:
1) MUSIC CONTROLLED MODE:
The laser runs a preprogrammed sequence to the rhythm of the music. Select this mode when only 1 laser
is used (standalone) or when the laser is placed as the first (master) unit in a chain with several units.
Press the FUNC-button until the display shows one of the following: Sou or Aut.
Please check carefully the Menu chart above.
Now use the UP or DOWN buttons to select <Sou=
Press the ENTER-button to confirm your choice.
You can connect several LASERs together: just put the first unit of the chain in one of the sound activated
effect modes and all other units in <Slave mode= (display shows <SLA=) to make them all work in perfect
sync!
Note: When no music is detected, the laser output will be shut off (blackout).
2) FULL AUTOMATIC MODE:
The laser automatically runs a preprogrammed sequence. Select this mode when only 1 laser is used
(standalone) or when the laser is placed as the first (master) unit in a chain with several LASERs.
Press the FUNC-button until the display shows one of the following: Sou or Aut.
Please check carefully the Menu chart above.
Now use the UP or DOWN buttons to select <Aut=
Press the ENTER-button to confirm your choice.
The laser automatically runs a preprogrammed sequence.
You can connect several SPACE-4 LASERs together: just put the first unit of the chain in one of the
automatic effect modes and all other units in <Slave mode= (display shows <SLA=) to make them all work in
perfect sync!
3) SLAVE MODE:
The laser follows the instructions given by the first SPACE-4 LASER (master) in the chain.
Connect the DMX input of the laser to the DMX output of the previous laser in the chain.
Press the FUNC-button until the display shows <SLA=
Press the ENTER-button to confirm your choice.
You can connect several lasers together. Please put the first unit of the chain in <Music or automatic
mode= and all other units in <Slave mode= (display shows <SLA= to make them all work in perfect sync!
®
JB SYSTEMS
5/54
USER MANUAL
SPACE-4 LASER
Advertenties
Inhoudsopgave
