Inhoudsopgave
Advertenties
DRAINAGE
Under high humidity conditions it may be necessary to empty the internal water tank. When the internal
water tank is full the display will show "P1". The cooling/dehumidification process will stop.
To empty the water tank do the following:
1. Switch off the appliance and remove the plug from the mains socket.
2. Place a water tray on the floor underneath the bottom drainage point.
3. Remove the drain cap and rubber plug from the drain and let the water run out.
4. Replace the rubber plug and drain cap, plug the appliance into the mains socket, and switch the
appliance on.
"P1" will disappear on the display.
If you wish to operate the appliance with no need to empty the water tank, please:
Remove the drain cap and rubber plug and retain for
future use.
Connect one end of the drain tube supplied to the bottom
drainage point and locate the other end into a drain.
Continuous drainage
Switch off the appliance and remove the plug from the mains
socket.
Remove the drain cap and rubber plug.
Connect the drain tub onto the water outlet and extend with extra
water tube if needed.
Place the other end in a normal drain. Make sure that the tube is
free from twists and bends.
NOTE: The drain must be at or below the outlet level.
EN-15
Advertenties
Inhoudsopgave
