Inhoudsopgave
Advertenties
Note
If the initialised HDD is not displayed, check the
connections.
1.
Select the HDD by ticking the corresponding box.
2.
Start the process by clicking on "Init".
3.
Confirm the prompt by pressing OK.
4.
The status bar shows the progress of the initialisa-
tion.
5.
The following appears after the process is complete.
Setting the HDD
Note
Define which status the HDD should have:
Read-only: The HDD is write-protected. Re-
cordings are made on the next HDD.
Warning:
If only one HDD is installed and this is set to
"Read-only", then the device cannot make re-
cordings.
Redundancy:
At least two HDDs are installed.
The redundant HDD makes an extra copy of the
recordings. This is used as a data backup.
•
R/W
At least one HDD must have the R/W status
(Read/Write). Otherwise, no recordings are possible.
Checking the HDD status
The status of each HDD can be checked in the "Mainte-
nance" menu. S.M.A.R.T. information (Self-Monitoring,
Analysis and Reporting Technology) is stored in the log
data.
•
Call up the log file and search according to the infor-
mation/S.M.A.R.T. HDD (see page 42).
Setting up the HDD alarm
You can specify alarms to inform you of HDD errors.
•
To do this, call up "Exception" in the "System Set-
tings" menu (see page 39).
Device menu
91
Advertenties
Hoofdstukken
Inhoudsopgave
