Inhoudsopgave
Advertenties
Device menu
HDDs
Note
The device manages one 3.5" SATA hard disk
drive.
The installed HDD must be initialised before the
device can be used for recording. The device only
detects the HDD and its assignment after initiali-
sation has been made.
Warning
All data is deleted from the HDD during initialisa-
tion.
Ensure a data backup has been made in good
time beforehand.
Installing the HDD
1.
Disconnect the device from the mains power and
open the cover.
2.
Observe the applicable ESD guidelines when han-
dling electronic devices and ensure they are earthed.
3.
Do not open the device in rooms with carpets or
other surfaces that can become electro statically
charged.
4.
Avoid bodily contact with all components on the
PCB.
Warning
If you have questions regarding the information or
cannot find the information you need, please con-
tact your maintenance specialist.
5.
Install the HDD and then connect it.
6.
Reattach the cover and connect the device to the
mains power supply.
7.
Switch on the device and start the HDD menu.
Initialising the HDD
90
HDD Management parameters
"General" tab
Label
Shows the internal connection num-
ber
Capacity
HDD capacity (in GB)
Status
Shows the current status of the HDD:
Not initialised
Normal
Error
•
Property
Redundancy: Works redundantly
for data security
•
Read-only: Read-only protection
•
R/W: Read and write
Type
Local: Device HDD
NFS: Network HDD
Free Space
Shows the approximate free memory
for recordings
Group
HDD group (1 is preset)
Recordings can be assigned to
groups
"Set Cameras for HDD Group" tab
Analog
Overview of cameras
Used for accessing the selected
camera group
Data Backup
1 to 8
on HDD Group
Advertenties
Hoofdstukken
Inhoudsopgave
