– Keep the instrument away from sources of heat.
– Do not use the instrument under blankets, pillows etc.
– The instrument must not be operated continuously for longer than 15 minutes. After this time,
wait an interval of at least 30 minutes to prevent the motor from overheating.
– Do not use the instrument when bathing or showering. Do not store or keep the instrument in
places from where it could fall into a bath or wash basin.
– Never immerse the instrument in water or other liquids.
– If the instrument has dropped into water, unplug the plug-in power unit immediately.
– Ensure your hands are dry before handling either the instrument or the plug-in power unit.
– Do not pull on the power cord or instrument to unplug the plug-in power unit from the socket outlet.
– The plug-in power unit must be operated only from a power supply as specified on it.
– If the power supply is damaged, don't use the adaptor anymore!
2. Commencing operation
2.1 Information concerning the instrument
This manicure and pedicure instrument is equipped with high-quality attachments. The basic ver-
sion includes three attachments with long-life sapphire coating or polishing felt. This, together
with the smooth speed control and clockwise/anticlockwise running, allows professional foot and
nail care such as is otherwise possible only from a chiropodist.
Individual treatments can be provided and the highest demands met with a Profiset with an ad-
ditional six attachments in extremely high quality long-life versions. This upgrade set an be inte-
grated without problem in the MP 60 instrument case. You have the best equipment with the MP
60 instrument and the MP 60 professional set attachments. This can otherwise be offered only by a
professional chiropodist.
2.2 Power supply
To ensure adequate power at all times for good and powerful treatment of the feet and nails, this
instrument is provided with a permanently attached power unit.
3. Application
3.1 General
– This instrument is intended only for the treatment of hands (manicure) and feet (pedicure).
– Select an attachment and push it onto the instrument spindle using a slight pressure. The at-
tachments can be heard to engage. To remove: pull the attachment and instrument apart in the
axial direction (straight).
– Switch on the instrument by sliding the slide switch to the left (anticlockwise running) or to the
right (clockwise running). The two buttons marked with plus (+) and minus (-) allow you to se-
lect the speed of rotation. Start every application at low speed and increase it only as required.
– All file and cutting attachments are coated with a sapphire grain. This guarantees extremely long
life and almost guarantees freedom from wear.
– Do not exert heavy pressure and always guide the attachments carefully over the surface to be
treated.
– Move the instrument under light pressure in circular movements slowly over the parts to be treated.
– Note that the cutting attachments will have a reduced effect if the skin is softened or moist. For
this reason, do not carry out any pretreatment in a bath.
– Do not remove all the callus skin in order to retain the natural protection of the skin.
– Always ensure that the spindle can rotate freely. It must never be permanently jammed, other-
wise the instrument will become too hot and suffer damage.
– After every use, apply moisturizing cream to the parts treated.