Inhoudsopgave
Advertenties
INTENDED USE
Flashlight is a cordless and portable source of light. Light is produced
by energy saving LED diodes. Unlike traditional light bulbs, LED
diodes are resistant to mechanical impacts and their lifetime reaches
10,000 hours.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the
drawing pages of this manual.
Reflector casing
1.
Joint axis
2.
Switch
3.
Handle
4.
Battery installation socket
5.
Holder
6.
Battery
7.
Battery lock button
8.
LED diodes
9.
Charger
10.
Button for battery level indication
11.
Battery level indicator (LED)
12.
* Differences may appear between the device and drawing.
PREPARATION FOR OPERATION
REMOVING AND INSERTING THE BATTERY
• Push the battery lock button (8) and slide out the battery (7)
(fig. A).
• Insert charged battery (7) into the battery installation socket
(5), you should hear when the battery lock button (8) snaps.
BATTERY CHARGING
The device is supplied with partially charged battery. The battery
should be charged in ambient temperature between 4°C and 40°C.
New battery, or one that has not been used for a long time, will reach
full efficiency after approximately 3 to 5 charge/discharge cycles.
• Remove the battery (7) from the device (fig. A).
• Connect the charger to mains socket (230 V AC).
• Slide the battery (7) into the charger (10) (fig. B). Ensure the
battery is properly fitted (pushed to the end).
When the charger is connected to a mains socket (230 V AC), the
green diode (9) on the charger turns on to indicate connected
supply.
When the battery (7) is placed in the charger (10), the red diode (9)
on the charger turns on to indicate that the charging is in progress.
At the same time green diodes (12) of the battery level indication are
flashing in different configurations, see description below.
• All diodes are flashing - battery is empty and requires
charging.
• 2 diodes are flashing - the battery is partially discharged.
• 1 diode is flashing - the battery level is high.
Once the battery is charged, the diode (9) on the charger lights
green, and all battery level diodes (12) light continuously. After
some time (approx. 15 s) battery level indication diodes (12) turn off.
Do not charge the battery for more than 8 hours. Exceeding this
time limit may cause damage to battery cells. The charger will
not turn off automatically when the battery is full. Green diode
on the charger will remain on. Battery level indication diodes turn
off after some time. Disconnect power supply before removing
the battery from the charger socket. Avoid consecutive short
chargings. Do not charge the battery after short use of the tool.
Significant decrease of the period between chargings indicates
the battery is worn out up and should be replaced.
Batteries heat up when charging. Do not operate just after
charging – wait for the battery to cool down to room temperature.
It will prevent battery damage.
BATTERY LEVEL INDICATION
The battery is equipped with signalisation of the battery level (3
LED diodes) (12). To check battery level status, press the button
for battery level indication (11) (fig. C). When all diodes are on, the
battery level is high. When 2 diodes are on, the battery is partially
discharged. When only one diode is on, the battery is discharged
and must be recharged.
OPERATION / SETTINGS
SWITCHING ON / SWITCHING OFF
Switching on – press the switch button (3) (fig. D).
Switching off – press the switch button (3) again.
SETTING ANGLE OF THE REFLECTOR CASING
Joint axis (2) allows to change position of the reflector casing (1)
related to the handle (4) to one of the four positions (fig. E).
TECHNICAL PARAMETERS
RATED PARAMETERS
Cordless Flashlight
Parameter
Supply voltage
Power
Number of diodes
Luminous flux
Colour temperature
Light angle
Working temperature range
Weight without battery
Protection class
Year of production
Energy+ System Battery
Parameter
Battery
Battery voltage
Battery type
Battery capacity
Ambient temperature range
Charging time for charger 58G002
Weight
Year of production
Energy+ System Charger
Parameter
Charger type
Supply voltage
Power supply frequency
Charging voltage
Max. charging current
Ambient temperature range
Charging time of the battery 58G001
Charging time of the battery 58G004
Protection class
Weight
Year of production
10
Value
18 V DC
3 W
3
260 lm
7000 K
120°
-10°C ÷ 45°C
0,260 kg
III
2021
Value
58G001
58G004
18 V DC
18 V DC
Li-Ion
Li-Ion
2000 mAh
4000 mAh
4
C – 40
C
4
C – 40
C
0
0
0
0
1 h
2 h
0,400 kg
0,650 kg
2021
2021
Value
58G002
230 V AC
50 Hz
22 V DC
2300 mA
4
C – 40
C
0
0
1 h
2 h
II
0,300 kg
2021
Advertenties
Inhoudsopgave
