Inhoudsopgave
Advertenties
EN
D. Connect the Smoke Smart Connect & Link
Smoke Detector to your mobile phone
1. A 2.4 GHz WiFi network is required to connect. If your network
broadcasts on both 2.4 and 5 GHz, disable 5 GHz during the
pairing process (as per your router manual).
2. Install the Tuya Smart- or Smart Life-app on your smartphone by scanning the QR-code
05
Figure 2: Turn on Bluetooth in app
Figure 1: Add Device in app
3. Enable Bluetooth via settings on your phone. The app
also needs permission to use Bluetooth.
4. Activate pairing mode by pressing the test button 3
times within 1 second of the Aroha Smart Connect &
Link Smoke Detector (with the WiFi-logo on the back). If
this is done correctly, the red LED will flash rapidly. After
a few seconds this will change to a green LED that
flashes rapidly for 1 minute. Within this minute you can
connect the detector to your app.
5. Click on the "+" in the top right corner of the app
home screen. Then choose "Add device", as you see in
Figure 1. The app will now automatically look for devices
that are in pairing mode. Follow the steps as described
in the app.
If the app itself does not yet have permission to use
Bluetooth, click on the notification and follow the steps
to allow the app to access Bluetooth as you see in
Figure 2.
Frequently Asked Questions
Alarm: If an alarm sounds when you try to activate
pairing mode, a test is activated because you did
not press fast enough. After the alarm stops, try
pressing the test button again 3 times as quickly as
possible within 1 second.
Low battery:
The
connected, the app may incorrectly report that the
battery is low. Push the test button or disconnect
the smoke detector and then reconnect it. If the
notification is given again by the app, please
contact us.
first
time
the
detector
is
Advertenties
Inhoudsopgave
