Inhoudsopgave
Advertenties
EN
Aroha Smart Connect & Link Smoke Detector
User manual
Please read the manual carefully to ensure safe, proper use and store it in a
safe
place
for
www.aroha.nl/manual
install your detector and consult the FAQ.
A. Activate/Deactivate the detector
The device is deactivated by default before leaving our factory.
Before the detector can be used, it must be activated.
Power on: Press and hold the test button (= centre front of detector) until the red LED lights up
and a beep sounds; this takes at least 10 seconds. After you release the test button the detector
is activated and can be used.
Power off: Press and hold the test button (= centre front of detector) until the red LED lights up
twice and a beep sounds twice; this takes at least 10 seconds. After you release the test button
the detector is deactivated and cannot be used.
CAUTION
The installation instructions must be
followed
strictly
conditions.
Do not paint your detector.
The battery cannot be replaced; do not
try to replace the battery as this will
render the detector unusable and can
cause a fire due to the high-capacity
lithium battery.
B. LED indicators
Mode
Normal status:
Alarm & Test status:
Silence mode:
Low battery status:
Fault status:
03
future
reference.
for the step-by-step instructions with video to safely
to
avoid
unsafe
LED
Green, 1x every 56 seconds
Red, 1x every second
Red, 1x every 8 seconds
Red, 1x every 56 seconds
Red, 1x every 40 seconds
Scan
the
QR-code
or
visit
Smoke inlet
85 dB alarm
Test/silence button
LED light
Audible alarm/beep
1x every second
1x every 8 seconds
1x every 56 seconds
1x every 40 seconds
Advertenties
Inhoudsopgave
