Advertenties
Cleaning with the floss attachment
You can use the floss attachment 0 to clean interdental spaces with the aid of dental floss.
Place the floss attachment 0 on the handset.
♦
♦
Take around 15 cm of standard commercial dental floss and wrap one end
2–3 times around the locking screw q.
NOTE
If the dental floss slips off the locking screw q, you can retighten it with a Phillips
►
screwdriver.
Pass the dental floss taut through the guide grooves w on the floss attachment 0.
♦
Then wrap the other end 2–3 times around the locking screw q so that the dental
♦
floss is stretched taut and does not come undone while cleaning the interdental
spaces.
♦
Guide the dental floss between two teeth with the toothbrush switched off.
Use the On/Off button 3 to select the programme. When cleaning with the floss
♦
attachment 0, use the programmes
♦
Clean the interdental space with careful up-and-down movements.
♦
Clean all the interdental spaces as described above.
♦
After two minutes, the toothbrush stops.
Remove the dental floss from the locking screw q and dispose of it.
♦
After use, clean the floss attachment 0 thoroughly under running water.
♦
Remove the floss attachment 0 from the handset. To clean the drive shaft 2 and the
♦
handset, hold them under running water for a short while. Hold the handset so that
the drive shaft 2 is pointing downwards at an angle.
NSZB 3.7 C4
(Normal) or
(Sensitive).
GB │ IE
│
27
■
Advertenties
Hoofdstukken
