Inhoudsopgave
Advertenties
The chisel is locked by the chisel lock(C). To insert and remove the chisel, please follow the steps
below:
To assemble:
1. Pull out the chisel lock(C), and then rotate it clockwise 1800.
2. Insert new chisel into the chuck.
3. Turn the chisel lock counterclockwise and then release it, the pin will automatically lock the chisel.
To remove:
1. Pull out the chisel lock(C), and then rotate it clockwise 1800.
2. Remove the old chisel by pulling it out directly.
On/Off switch
Use the On/Off switch to start the machine and keep holding it for continuous operation.
To switch the machine off, release the On/Off switch
WARNING
Don't apply too much pressure to the machine.
The chiseling mechanism is activated by applying a slight pressure on the tool
when the drill bit is in contact with the workpiece.
The best cutting effect can be achieved by applying slight pressure to the tool
that maintains the automatic clutch engagement.
Replacing of carbon brushes
The carbon brushes are expendable. It is keeping abrasion during use.
The carbon brushes should be changed regularly. In order not to damage the electrical circuit, both
carbon brushes should be changed at the same time.
CAUTION!
Exchanging the carbon brushes should be done by authorized service only.
The machine should be used only with both brushes!
APPLICATION ADVICE
Be sure to use the auxiliary handle provided with this tool. Well controlled machine may
increase the working precision greatly.
Unplug the appliance before maintenance.
Keep the ventilation openings clear and clean the product regularly.
If an exception occurs during use, please turn off the power and disconnect the plug.
Please inspect and repair the tool before using it again.
Repair of the tool must only be carried out by qualified repair technicians.
Repair or maintenance by unqualified personnel can lead to a risk of injury.
Only the same spare parts can be used for repairing.
MAINTENANCE
08
Advertenties
Inhoudsopgave
