Inhoudsopgave
Advertenties
GB
Technical data
Voltage:
Power absorbed:
Admissible working conditions:
INTERMITTENT - S3-SERVICE
30 sec. under load running
Rotation speed:
Capacitor:
IP Degree:
Thermal Circuit Breaker:
Weight
Tank capacity
Tool:
CONTINUOUS CROWN DIAMOND BLADE
Diameter:
Centre hole:
Max. cut length
Max. cutting depth:
40 mm - cut 90° / 40 mm cut 45°
Water recirculation pump:
Recommended use:
CERAMIC, SINGLE-FIRED CERAMIC, COTTO
AND MARBLE (max. thickness 20 mm.)
All manuals and user guides at all-guides.com
1. Use
230V 50Hz~
Before using the machine read the safety
1000W
instruction chapter carefully.
All machines have been thoroughly tested and
checked before leaving our factory.
Carat Centrale B.V. works for a continuous
development of the machines the company
manufactures, therefore the company reserves
the right to modify its models. No rights can be
30 sec. repose
therefore claimed as far as data and pictures of
2800 min
-1
this manual are concerned.
18 µF
The CARACOUP diamond blade cutting machine is
suitable for cutting any type of ceramic material. It
44
can also be used to carry out 90° as well as 45° cuts
170°C
(jolly). The cutting depth and inclination can both be
adjusted.
34 Kg
25 L
2. Precautions
•
WET CUTTING
Ø200 mm
•
25,4 mm
600 mm
•
•
S1 230V 50Hz
Keep in mind the following tips:
•
•
•
•
During cutting operations dangerous splinters may
come off.
18
CAUTION !
The manufacturer declines any liability for the
use of any CARACOUP tile cutter with tools
other than the original ones and for the cutting
of materials not indicated in the paragraph
"RECOMMENDED USE".
The
CARACOUP
is
exclusively according to the ADMISSIBLE
WORKING CONDITIONS indicated in the
paragraph: "TECHNICAL DATA".
During the cutting phase it is therefore
recommended to interrupt the working cycle as
indicated.
The CARACOUP was not designed to work
under continuous load.
CAUTION !
Let the motor slide slowly. Avoid any disk
blocking.
Make sure that the piece to be cut is duly
leaned against the tile stopper.
Before any cutting operation make sure that
the adjustment knobs for cutting inclination
are tightened.
After some cutting sharpen the disk with a
hone.
CAUTION !
designed
to
work
Advertenties
Inhoudsopgave
