Inhoudsopgave
Advertenties
EN
6
Use
6.1
General
Check the equipment for completeness and damage. Do not use the equipment if it is damaged; in that
case contact the Holmatro dealer.
WARNING
Make sure you are up to date on all safety regulations and that you have mastered the use
of all equipment of the system you are going to work with.
6.2
Before use
6.2.1
General
Use the pump only for tools that require an hydraulic oil volume that is less than the maximum available
oil volume.
•
Position the pump on a solid level base.
•
Check the hydraulic oil level.
•
Connect the motor to the correct power supply that corresponds with the information on the model
plate.
CAUTION
Never pull the power supply cable and prevent damage to the cable.
The system is now ready for use.
6.3
During use
6.3.1
Operate the pump
•
Keep the "ON" button (Fig. 3/4) pressed to run the pump.
•
Release the "ON" button to stop the pump. The pressure in the system will be maintained.
•
Press the "OFF" button (Fig. 3/4) to open the pressure relief valve to depressurize the system.
6.3.2
Change a tool
•
Disconnect the hose from the tool in use. Refer to chapter 5.3.
•
Connect the hose to the other tool. Refer to chapter 5.2
6.4
After use
6.4.1
Shut down and disconnect
•
Stop the pump and depressurize the system.
•
Disconnect the hydraulic hose(s) from the tool and the pump. Refer to chapter 5.3.
•
Disconnect the power cord.
6.4.2
Inspection
•
Check the pump for completeness, oil leaks and damage. Do not use the pump if it leaks or is
damaged and contact the Holmatro dealer.
•
Check the level of the hydraulic oil in the tank, and add oil if necessary.
30
916.219.569_003
EHW
Advertenties
Inhoudsopgave
