Inhoudsopgave
Advertenties
EN
5.1.2
High-Flow couplers
The High-Flow coupler is a screw-on coupler used on a single or duo-hose system.
In case of duo hoses, the supply hose and the return hose are bundled together with ties. Each end of
both hoses has the same coupler: female and male couplers.
If you want to connect or disconnect a tool and/or a hose, you must depressurize the system first.
5.2
Connect the hydraulic hose
5.2.1
General
WARNING
Never use damaged couplers.
CAUTION
Never use pliers or similar to connect the hydraulic couplers.
5.2.2
Connect the High-Flow coupler
Refer to Fig. 4.
WARNING
Always make sure that the system is depressurized by pressing the "OFF" button on the
pump before you connect hydraulic hose(s) to the pump.
•
Remove the dust caps from the female and male couplers.
•
Check the couplers for dirt and damage and clean them if necessary.
•
Screw the male coupler into the female coupler and tighten the locking ring as far as possible.
•
Screw the dust caps together, to prevent from contamination.
5.3
Disconnect the hydraulic hose
5.3.1
General
CAUTION
Never use pliers or similar tools to disconnect the hydraulic couplers.
5.3.2
Disconnect the High-Flow coupler
Refer to Fig. 5.
WARNING
Always make sure that the system is depressurized by pressing the "OFF" button on the
pump before you disconnect hydraulic hose(s) from the pump.
•
Disconnect the dust caps from each other.
•
Unscrew the locking ring. The male coupler will be released.
•
Clean the couplers and the dust caps.
•
Replace the dust caps on the female and male couplers.
28
916.219.569_003
EHW
Advertenties
Inhoudsopgave
