Download Inhoudsopgave Inhoud Print deze pagina

Swimming Pool Heat Pumps Location; How Close To Your Pool; Swimming Pool Heat Pumps Plumbing - Norsup P13V/32 Gebruiksaanwijzing

Zwembad warmtepomp
Inhoudsopgave

Advertenties

SWIMMING POOL HEAT PUMP TYPE PV

3.2 SWIMMING POOL HEAT PUMPS LOCATION

The unit will perform well in any outdoor location
provided that the following three factors are
presented:
1. Fresh Air - 2. Electricity - 3. Pool filter piping
The unit may be installed virtually anywhere outdoors.
For indoor pools please consult the supplier. Unlike a
gas heater, it has no draft or pilot light problem in a
windy area.
DO NOT place the unit in an enclosed area with a
limited air volume, where the units discharge air will
be re-circulated.
DO NOT place the unit to shrubs which can block air
inlet. These locations deny the unit of a continuous
source of fresh air which reduces it efficiency and may
prevent adequate heat delivery.
Air outlet

3.3 HOW CLOSE TO YOUR POOL?

Normally, the pool heat pump is installed within 7.5
metres of the pool. The longer the distance from the
pool, the greater the heat loss from the piping. For the
most part, the piping is buried. Therefore, the heat
loss is minimal for runs of up to15 meters (15 meters to
and from the pump = 30 meters total), unless the
ground is wet or the water table is high. A very rough
estimate of heat loss per 30 meters is 0.6 kW hour,
(2000BTU) for every 5°C difference in temperature
between the pool water and the ground surrounding
the pipe, which translates to about 3% to 5% increase
in run time.
14
WWW.NORSUP.EU
Air inlet

3.4 SWIMMING POOL HEAT PUMPS PLUMBING

The Swimming Pool Heat Pumps exclusive rated flow
titanium heat exchanger requires no special
plumbing arrangements except bypass (please set
the flow rate according to the nameplate). The water
pressure drop is less than 10kPa at max. Flow rate.
Since there is no residual heat or flame Temperatures.
The unit does not need copper heat sink piping. PVC
pipe can be run straight into the unit.
Location: Connect the unit in the pool pump
discharge (return) line downstream of all filter and
pool pumps, and upstream of any chlorinators,
ozonators or chemical pumps. Standard model have
slip glue fittings which accept 32mm or 50 mm PVC
pipe for connection to the pool or spa filtration piping.
By using a 50 NB to 40NB you can plumb 40NB Give
serious consideration to adding a quick coupler fitting
at the unit inlet and outlet to allow easy draining of
unit for winterizing and to provide easier access
should servicing be required.
Condensation: Since the Heat pump cools down the
air about 4 -5, water may condense on the fins of the
horseshoe shaped evaporator. If the relative humidity
is very high, this could be as much as several litres an
hour. The water will run down the fins into the base
pan and drain out through the barbed plastic
condensation drain fitting on the side of the base pan.
This fitting is designed to accept 20mm clear vinyl
tubing which can be pushed on by hand and run to a
suitable drain. It is easy to mistake the condensation
for a water leak inside the unit.
NB: A quick way to verify that the water is
condensation is to shut off the unit and keep the pool
pump running. If the water stops running out of the
base pan, it is condensation. AN EVEN QUICKER WAY
IS to TEST THE DRAIN WATER FOR CHLORINE - if the
is no chlorine present, then it's condensation.
Alterations which serve the technological progress as well as errors excepted!

Advertenties

Inhoudsopgave
loading

Inhoudsopgave