Inhoudsopgave
Advertenties
SERVICING
Visor overlays (optional)
Install a new set of visor overlays by adhering to the main visor using the adhesive
strips provided.
Visor assembly replacement
•
Remove the seven face seal pop studs from visor as shown in Fig 6.
•
Replace the old or damaged visor assembly as shown in Fig 7:
•
Release nuts and push screws inwards, release the front tab and lift visor from the
helmet.
•
Fit replacement visor ensuring slot in visor locates on tab and bottom edge in
grooves, secure with screws and nuts.
•
Fit visor stiffener wire. Insert the wire ends into the outer slots provided and rotate
to engage securely in the centre slot.
Visors should be stored out of direct sunlight and replaced at least every 5 years.
Face seal
Replace the face seal as shown in Fig 6:
•
Starting from the centre of the visor pop studs on face seal. Release touch and
close tape from front of helmet.
•
Unfasten the crown strap on the headband and release elastic loops on each side.
•
Pull face seal over the headband knob and remove face seal from helmet.
•
Tuck edge strip of new face seal under headband and secure to touch and close
tape on helmet. Slip the elastic loops over the crown strap and adjust strap length.
•
Fit face seal over headband knob and secure to visor pop studs.
Face seals should be stored out of direct sunlight and replaced at least every 5 years.
Headband assembly
Remove face seal and visor as shown in Figs 6 and 7.
Install a new headband assembly as shown in Fig 8:
•
Release nuts and screw and remove the headband from the helmet.
•
Assemble anti-rotating cap and screw retainer to headband noting that Anti-
rotating caps are marked 'L' (left) and 'R' (right).
22
Advertenties
Inhoudsopgave
