Inhoudsopgave
Advertenties
Description
1. on/off button & timer button
2. pilot light
3. body of the shoe dryer
4. air intake grill (back)
5. drying hose (2x)
6. air outlet (2x)
Switching on and operation
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Place the unit straight, on a sturdy, flat and horizontal surface. Ensure there is
sufficient space at the back side (air inlet).
Place the shoes/boots that are to be dried for the
appliance and insert the drying hoses into the
boots/shoes. However, make sure that the warm air
that is blown out is then able to escape again;
therefore the hoses must not be inserted too tightly
into the boot/shoe, otherwise the appliance may
overheat!
Check that the control button is '0' (off).
Fully unwind the electric cable and insert the plug
into a suitable 220/240V socket.
By now turning the ON/OFF button anticlockwise to
ON, you switch on the appliance. It will draw in air from the rear, heat this up in the
appliance, blow this out through the hoses which will dry out the shoes/boots. During
operation, the indication light will be illuminated.
You turn off the appliance by turning the ON/OFF button clockwise to '0' (OFF).
Timer
The heater is equipped with a timer. When you wish to use that, do not turn the ON/OFF
button to ON, but from the OFF position clockwise to the required number of minutes of
operation (max. 120). The heater will now switch
on and the indicator light will be illuminated. Once the set time has ended, the heater will
automatically switch off (the light be no longer be illuminated).
Even when actual operation has ended, the timer will sometimes emit a gentle ticking
sound. That is not dangerous and it will stop of its own accord.
21
Advertenties
Inhoudsopgave
