Inhoudsopgave
Advertenties
Be careful not to damage the spindle, the
lock nut. Damage to these parts could result in
wheel breakage.
4.
Make sure the wheel is not contacting the
workpiece before the switch is turned on.
5.
Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced wheel.
6.
form the grinding.
7.
Do not leave the tool running. Operate the tool
only when hand-held.
8.
Do not touch the workpiece immediately after
operation; it may be extremely hot and could
burn your skin.
Observe the instructions of the manufacturer
for correct mounting and use of wheels.
Handle and store wheels with care.
10. Do not use separate reducing bushings or
adaptors to adapt large hole abrasive wheels.
11.
12.
hole wheel, ensure that the thread in the wheel
is long enough to accept the spindle length.
Check that the workpiece is properly
supported.
14. Pay attention that the wheel continues to
rotate after the tool is switched off.
15. If working place is extremely hot and humid,
or badly polluted by conductive dust, use a
short-circuit breaker (30 mA) to assure opera-
tor safety.
16. Do not use the tool on any materials contain-
ing asbestos.
17. When use cut-off wheel, always work with
the dust collecting wheel guard required by
domestic regulation.
18. Cutting discs must not be subjected to any
lateral pressure.
Do not use cloth work gloves during operation.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
All manuals and user guides at all-guides.com
FUNCTIONAL
DESCRIPTION
switched off and unplugged before adjusting or
checking function on the tool.
Shaft lock
-
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Fig.1: 1. Shaft lock
NOTICE:
spindle is moving.
Switch action
check to see that the slide switch actuates prop-
erly and returns to the "OFF" position when the
rear of the slide switch is depressed.
tion for ease of operator comfort during extended
use. Apply caution when locking tool in "ON"
To start the tool, slide the slide switch toward the "I
switch to lock it.
To stop the tool, press the rear of the slide switch, then
Fig.2: 1. Slide switch
Unintentional restart proof
NOTE:
NOTE: When the tool is overloaded and the tool
Soft start feature
ASSEMBLY
switched off and unplugged before carrying out
any work on the tool.
8 ENGLISH
CAUTION:
Always be sure that the tool is
Never actuate the shaft lock when the
CAUTION:
Before plugging in the tool, always
CAUTION:
Switch can be locked in "ON" posi-
CAUTION:
Always be sure that the tool is
Advertenties
Inhoudsopgave
