Inhoudsopgave
Advertenties
NOTE: to increase the cooling effect, you can cool the tap water in the refrigerator
beforehand. The water tank can be filled with ice cubes – for better cooling.
5. Figure D: place the filter 15 onto the water tank 16. Rotate the filter clockwise
until the marking
6. Dry the outside of the water tank 16.
7. Push the water tank 16 with the filter 15 back into the device 6.
8. Insert the front panel 14 at the bottom first. Then press it upwards so that the release
button 2 engages.
Filling the water tank 16 with 700 ml of water is sufficient for up to 7 hours of opera-
tion at speed setting 1.
5.4 Connecting the device
1. Plug the power unit 9 into a properly installed, easily accessible mains socket
whose voltage corresponds to that specified on the rating plate. The wall socket
must still be easily accessible after connection.
2. Insert the USB-C plug 10 into the USB-C port 11 on the back of the device 6. The
LED 1 lights up white once.
5.5 Switching the device on/off
NOTES:
• Wait approx. 2 minutes until the filter 15 has absorbed sufficient water. Then you
achieve the full cooling effect.
• If the front panel 14 is not closed, the device cannot be switched on. This is a
safety function.
• Press the on/off switch
once. The fan starts to operate at speed 1 (low speed).
• Press the on/off switch
10
GB
on the filter points to the marking
3 to switch the device 6 on. The LED 1 flashes red
3 again to turn off the device 6.
Lock on the water tank.
Advertenties
Hoofdstukken
Inhoudsopgave
