Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Assembly Instructions
Before beginning assembly, be sure to observe our recommendations
and safety instruction. Remove all the part of your cycle from the carton
and place them on the floor carefully. Some parts are pre-assembled.
Step 1:
Attach the stabilizer (33+72).
1.
Attach the front stabilizer (33) assembled with 2 front cross bar caps
(34) to main frame (62), using 2 bolts M8x55 (37), 2 washers (16) and
2 spring washers (13).
2.
Attach the rear stabilizer (72) assembled with 2 rear cross bar caps (69)
and 2 adjustable knob (70) to main frame (62), using 2 bolts M8x55 (37),
2 washers (16) and 2 spring washers (13). (For uneven floor you can
adjust the height with screw (70) and secure position with nut (71).)
Step 2:
Attach the pedals (36L+36R).
1.
Attach the pedal straps to the pedals (36R/36L).
2.
The pedals (36R/36L) are marked with „R" & „L"
NOTE: Right and Left are specified as viewed seated on the machine
during training. Connect each pedal (36R/36L) to the matching crank
arm (38L+38R)
(NOTE: The right pedal „R" should be threaded on clockwise.
The left pedal „L" should be threaded on counter-clockwise.)
Step 3:
Installation of saddle (24) at saddle post (31) by using saddle slide
(25). Installation of saddle post (31) at main frame by using rapid
action lock (21).
1.
Push the saddle (24) with saddle bracket into the movable saddle slide
(25) and tight it up in desired gradient position.
2.
Place the movable seat slide (25) into the holder of saddle post (31),
set it at the desired horizontally position and tighten it by washer (29)
and movable seat knob (30).
3.
Insert the saddle support (31) into the provided holder of the main frame
(62) and secure at the desired position by screwing in the rapid-action
lock (21).
(Note: To screw in the rapid-action lock (21), the threaded hole in the
main frame (62) and one of the holes in the saddle support (31) must
be aligned. Furthermore, ensure that the saddle support (31) is not
pulled out of the main frame beyond the marked maximum Position.
The setting of the saddle post can be adjusted as desired later. For this,
the rapid action catch (21) must be loosened by only a few revolutions,
the cap of the lock must be pulled away and the saddle adjusted. Then
secure the new setting by tightening the rapid action catch.
16
Advertenties
Inhoudsopgave
