Inhoudsopgave
Advertenties
Electrical wiring diagram
Device use
To switch on the pump set the On/Off switch to the On position. If the overcurrent circuit breaker is tripped by
a short circuit, overheating, etc., once the problem has been resolved (the cause of overcurrent circuit breaker
tripping), release the circuit breaker by pressing the circuit breaker button on the control panel housing.
Dismantling the pump
In areas where temperatures drop below zero, dismantle the pump for the winter season and store it in
accordance with the guidelines in „transport and storage" section.
To dismantle the pump:
•
Set the On/Off switch to the Off (" 0") position;
Disconnect the pump from the power source;
•
•
Extract the pump from the borewell using a steel or a different secure rope attached to the pump
handles;
Disconnect the water delivery pipe from the pump;
•
•
Empty any water remaining in the pump by turning it upside down;
Once the pump is dry, it is ready to be stored safely.
•
Transportation and Storage
•
Shaking, crashing and turning the device upside down should be prevented when transporting it. Store
it in a properly ventilated location with dry air and without any corrosive gas.
•
Store the device in ambient temperatures above zero in a horizontal position. If the pump has been
stored for more than a few days, ensure the device functions properly before installing it again.
Cleaning and Maintenance
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
•
replacement of accessories, or if the device is not being used. Wait for the rotating elements to stop.
Use only non-corrosive cleaners to clean the surface.
•
EN
1- Black
2- Blue
3- Brown
4- Yellow-green
Advertenties
Inhoudsopgave
