Assembly, Operation & Maintenance Instructions
6
in a prote cted spot (so it does not receive any fat splatter from cooking or can be
accidently knocked over). When using the stand, hang the gas cylinder from the
cylinder hook. If this cannot be done (due to the design or size of the cylinder),
the gas cylinder should be placed beside or behind the appliance, in a safe position
protected from any fat splatter.
19. This appliance is not suitable for mounting in a movable vehicle (boat, trailer etc).
20. Do not use or store this appliance in areas of high salt content (a marine environment)
or an area with caustic fumes or liquids (such as a domestic pool), as these chemi-
cals can cause the appliance materials to deteriorate (and void the warranty). Reg-
ular cleaning and covering with an everdure by heston blumenthal barbeque cover
can help can help to reduce this.
21. The appliance shall be supplied with an approved hose which is certified to
applicable EN Standards that is not exceeding 1.5m. For Finland, the hose length
shall not exceed 1.2m. The gas regulator should be certified according to EN16129
(flow rate max. 1.5kg/hr). These should be connected as per local regulations. Posi-
tion hose clamps and tighten. Do not allow the hose to kink or twist during installa-
tion and use. Change a new hose if leakage/blockage is sighted. It is suggested that
the hose is changed every 3 years.
DO NOT OPERATE THIS APPLIANCE BEFORE READING THE INSTRUCTION BOOKLET
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE
DO NOT STORE CHEMICALS OR FLAMMABLE MATERIALS OR SPRAY AEROSOLS NEAR THIS APPLIANCE
DO NOT OPERATE THIS APPLIANCE INDOORS
DO NOT ENCLOSE THIS APPLIANCE. THE MINIMUM CLEARANCE FOR THIS UNIT IS 1500mm ABOVE THE COOKING
SURFACE AND 250mm FROM ANY SIDE
DO NOT LIGHT WITH HOOD DOWN