Inhoudsopgave
Advertenties
ACCESSORIES
Remote controller
SAFETY PRECAUTIONS
This appliance is not intended for use by person (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
DANGER
• DO NOT ATTEMPT TO INSTALL THIS UNIT BY YOURSELF. THIS UNIT REQUIRES A QUALIFIED
INSTALLER.
• DO NOT ATTEMPT TO REPAIR THE UNIT BY YOURSELF. THIS UNIT SHOULD BE
PROFESSIONALLY REPAIRED.
• OPENING OR REMOVING THE COVER WILL EXPOSE YOU TO DANGEROUS VOLTAGES.
• TURNING OFF THE POWER SUPPLY WILL NOT PREVENT POTENTIAL ELECTRIC SHOCK.
WARNING
INSTALLATION WARNINGS
• Be sure to ask a dealer or a store specialized in electric work to install the air conditioner.
• If the air conditioner is improperly installed by yourself, it can cause some problems such as water leaks, electric shock, fire, and so
on.
• Be sure to always ground the air conditioner.
• Please request the dealer or a specialized technician to perform the grounding work. If the grounding work is performed improperly,
an electric shock can result.
• Do not connect the ground wire to gas pipes, water pipes, lightning rods or ground wires of telephones. If the air conditioner is
improperly grounded, it can cause an electric shock.
• Be sure to cover the pipe hole in the indoor unit panel if they are not used when re-installing the unit after moving or other operations.
If the electrical parts inside the unit are touched, an injury or electric shock can result.
• Be sure that the power supply has dedicated air conditioner circuit at the rated voltage. Otherwise, a breakdown or fire can result.
• Do not install in locations where the unit will get splashed by water or with high humidity such as bathrooms. This can cause
deterioration of the insulation, resulting in an electric shock or fire.
CAUTION
TO DISCONNECT THE APPLIANCE FROM THE MAIN POWER SUPPLY
A switch or circuit breaker that can disconnect all poles must be included in the fixed wiring. Be
sure to use an approved circuit breaker or switch.
Remote controller holder
1
Batteries (two)
EN
Advertenties
Inhoudsopgave
Probleemoplossen
