Inhoudsopgave
Advertenties
Description of the Appliance
The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
Illustrations on Page 2
1
High pressure connection
2
Appliance switch „0/OFF" / „I/ON"
3
Storage for mains cable
4
Mains cable with mains plug
5
Storage for high pressure hose
6
Carrying handle
7
Storage for spray lance
8
Storage for trigger gun
9
Water connection with integrated sieve
10 Water filter
11 Coupling element for water connection
12 Nameplate
13 Trigger gun
14 Lock trigger gun
15 High pressure hose
16 Clamp for high pressure hose
17 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks.
The working pressure can be continuously in-
creased from "SOFT" to "HARD". To adjust the
working pressure, release the trigger gun lever and
turn the spray lance to the desired position.
18 Spray lance with Dirtblaster
For strong contaminations.
19 Foam nozzle with detergent container
** Additionally required
20 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
Installation and Startup
Illustrations on Page 3
Illustration
Mount loose parts delivered with appliance prior to
start-up.
Illustration
Pull out the clamp from the trigger gun and plug the
high-pressure hose into the trigger gun.
Push the clamp in until it locks. Check the secure
connection by pulling on the high-pressure hose.
Illustration
Start up
ATTENTION
Impurities in the water can damage the high-pressure
pump and the accessories. For protection, the use of
the KÄRCHER water filter (optional accessory, order
no. 4.730-059) is recommended.
CAUTION
Dry running of more than 2 minutes leads to damage of
the high-pressure pump. If the appliance does not build
up pressure within 2 minutes, switch the appliance off
and proceed in accordance with the instructions in
Chapter "Troubleshooting".
High pressure operation
CAUTION
Keep a distance of at least 30 cm when using the jet for
cleaning painted surfaces to avoid damage.
ATTENTION
Car tyres, paint or sensitive surfaces such as wood
should not be cleaned with the dirt blaster, as there is a
risk of damage.
Park the appliance on an even surface.
Illustration
Cleaning
Operation with detergent
With powerful foam for effortless cleaning.
Illustration
Fill the detergent solution in the detergent tank of
the foam nozzle (observe dosage instructions on
the packaging of the detergent).
Connect the detergent tank to the foam nozzle.
Connect the foam nozzle to the trigger gun.
Recommended cleaning method
Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
Spray off loosened dirt with the high pressure jet.
Interrupting operation
Illustration
Release the lever of the trigger gun and lock it.
During longer breaks (more than 5 minutes), also
turn the appliance off using the "0/OFF" switch.
CAUTION
Only separate the high-pressure hose from the trigger
gun or the device when there is no pressure in the sys-
tem.
Release the lever of the trigger gun.
Turn off the appliance "0/OFF".
Disconnect the mains plug from the socket.
Turn off tap.
Press the lever on the trigger gun to release any
remaining pressure in the system.
Lock the lever of the trigger gun.
Detach the appliance from the water supply.
– 5
EN
Operation
Finish operation
9
Advertenties
Hoofdstukken
Inhoudsopgave
