Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ENGLISH
A5 warning
The motor's
temperature is
too high.
A7 warning
The change in
speed could
not be done
successfully.
A8 warning
Wrong NTC
sensor reading.
A12 warning
Maximum weight
exceeded.
A13 warning
Calibration error.
Stuck jar.
8. TECHNICAL SPECIFICATIONS
Product reference: 04345/04346
Model: Mambo Touch /Mambo Touch + Habana Jug
1600 W (Motor 600 W Heating power 1000 W) 220-240 V~ 50/60 Hz
Frequency band: 2.400 - 2.4835 GHz
Made in China | Designed in Spain
68
The food processor has been
operating with too much
food for a lot of time.
Speed change between low
level (1-5) and high level
(6-10) was blocked.
The temperature sensor is
not working properly.
The maximum measurement
value has been exceeded.
Scale calibration failed.
The jug release system does
not work.
Stop operating the food
processor and allow it to
cool down before restarting
it again.
Remove the jar, turn the
fixing bracket manually and
place the jar again in place.
Restart the food processor.
Contact the Technical
Support Service of Cecotec.
Remove weight from the
scale until it reaches a
value below 4.999 g.
Repeat the process. If the
problem persists, please
contact Cecotec's Technical
Support.
Restart the food processor
and wait a few seconds.
If the problem persists,
there is a manual release
lever on the bottom of the
main body. Pull this lever to
release the jug lock.
Advertenties
Inhoudsopgave
Probleemoplossen
