Power Supply
The included rechargeable batteries may also be replaced
by non-rechargeable Mignon AA / R6, 1.5 V batteries.
WARNING: Danger of explosion!
Do not charge!
• When using the appliance with non-rechargeable
batteries, make sure that under no circumstances it is
being connected with the power adapter.
• If you put the appliance equipped with non-recharge-
able batteries into the stand / charging station, the
power adapter shall under no circumstances be
connected to it.
Overview of the Components /
Scope of Delivery
1 Clipper head
2 Switch for thin-out function
3 Appliance
4 On / off switch
5 Charging indicator light
6 Stand / charging station
7 Cutting length combs (4, 10, 14 and 18 mm)
No illustration:
Power adapter
Cleaning brush
2 × rechargeable batteries (Accumulators)
Type AA / R6, 1.2 V, 600 mAh, NiMH
Inserting the Batteries /
Rechargeable Batteries
1. Take the appliance and the rechargeable batteries out of
its packaging.
2. Open the battery compartment at the back of the
appliance.
3. Insert both batteries (2 × 1.2 V type AA / R6, 600 mAh,
NiMH). Pay attention to the correct polarity (see bottom
of battery compartment)!
4. Close the battery compartment again.
Charging the Rechargeable Batteries
WARNING:
Please ensure that rechargeable AA / R6, NiMH, 600 mAh
batteries (accumulators) are inserted in the battery
compartment. Risk of explosion: when trying to charge
non-rechargeable batteries.
CAUTION:
Do not charge the rechargeable battery unsupervised.
36
PC-HSM-R3013_IM_new2
1. Turn the appliance off: Slide the
can be seen on the switch.
2. Connect the power adapter connector with one of the
following jacks.
• The socket directly at the bottom end of the appliance.
• Alternatively place the appliance in the charging
station. The socket is at the rear.
3. Plug the power adapter into wall outlet.
4. Charge the appliance before first use for 12 hours.
NOTE:
• The indicator light remains red during the charging
process.
• The charge indicator does not indicate the state of
charge of the rechargeable battery.
• Mere mains operation is not possible.
5. After initial use, do not charge the battery for longer than
10 hours at one time.
CAUTION:
After 10 hours always disconnect from mains power
supply.
NOTE:
You can extent the lifetime of the rechargeable battery by
following these steps:
• Only charge after the battery is nearly exhausted.
• Do not charge for more than 10 hours.
• Charge the appliance at temperatures between 0 °
and + 40 °C.
• Even when switched off, the rechargeable battery
discharges continuously. If the appliance is out of use
for a longer period of time, charge the rechargeable
battery at least once every 4 to 6 weeks.
• In case the rechargeable batteries are faulty, replace
them with two new ones of the same types. Observe
the details under "Technical Data".
Using the Appliance
Switching On and Off
Slide the switch
to turn the appliance on or off.
Adjust Cutting Length
1. Turn off the appliance. "ON" can be seen on the switch.
2. Select a comb attach-
ment. The comb attach-
ments are labelled with
numbers.
3. Attach the desired
comb: Also refer to fig-
ure B on page 3. Slide
the blades of the clipper
head into the jags of the comb.
4. To remove the comb attachment, pull it off the clipper
head.
switch down. "ON"
Cutting length
Number
in mm
1
approx. 4
2
approx. 10
3
approx. 14
4
approx. 18
25.03.21