Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Ensure the product is mounted to provide ade-
quate heat-circulation.
Do not cover the product with blankets, cushions,
or similar heat insulating materials.
Use the product only with the parts described
in this instruction manual.
If the LED rope light
any length of time (e.g. holidays), disconnect
it from the power supply.
Keep away from ponds and other water reservoirs.
Install the LED rope light
away from water containers. Avoid place that
might flood after heavy rainfall.
If using the LED rope light
sure it is connected to a socket which is protected
with a faulty voltage protection switch (FI or RCD)
for a maximum faulty voltage up to 30 mA.
The LED rope light
1
splashes of water (IP44) as long as the socket
meets the minimum protection standard.
Make sure the LED rope light
down in areas where lawn mowers, trimmers,
scissors or similar cutting tools are used.
Do not pull the LED rope light
it is laid down properly so that no one walks or
trips over it.
If in any doubt about the safe installation or
use of this product, please consult a qualified
electrician.
Installation safety instructions
Make sure that the product is only installed by
competent persons.
The LED rope light
1
normally inflammable surfaces with the enclosed
mounting parts.
CAUTION! RISK OF ELECTRIC SHOCK!
Make sure that there are no power, gas or water
lines located where you wish to drill. Check with
a cable and pipe locator if necessary before
you begin drilling.
Before installation, check whether the surface is
suitable for the mounting parts and the weight
of the LED rope light
consult an electrical specialist for advice.
6
GB/IE/NI
is not to be used for
1
at least 2 metres
1
outdoors, make
1
is protected against
is not laid
1
and make sure
1
can be installed on all
. If you are in any doubt,
1
Do not use sharp and / or pointed objects such
as wire, nails or fasteners for mounting.
Do not attach any additional objects to the
LED rope light
.
1
Avoid excessive bending of the LED rope
light
. This can damage the insulation.
1
The bending radius of the rope must not fall
below the following value: rope diameter
between 10–14 mm: 2 cm.
Avoid excessive heating of the LED rope light
A maximum of two sections of rope may cross
or run parallel to each other.
Installation
Note: Remove all packaging materials from the
product before use.
First, please unroll the product before use.
Note: The LED rope light
all surfaces officially classified as being of "normal
flammability" by means of the supplied attachments.
Please fix the LED rope light
surface and fix the product by attaching it with
the help of the included cable ties
Alternatively, you can also mount the product
by using the included attachment clips
place the attachment clips
and fix them with the included screws
using a crosshead screwdriver. Once the required
attachment clips
2
press LED rope light
ment clips
. You may further use the cable
2
tie
to secure the LED rope light
3
attachment clips
2
Use
Plug the mains plug into the socket.
The lighting is switched on.
Press the timer button
lighting mode. When you reach lighting mode 8,
the next press of the button switches the product
back into lighting mode 1.
can be mounted on
1
on the desired
1
.
3
. Firstly,
2
in a sturdy surface
2
by
4
have been attached, you can
into the opening of attach-
1
onto the
1
if need.
to switch to the next
5
.
1
Advertenties
Hoofdstukken
Inhoudsopgave
