Inhoudsopgave
Advertenties
Assembly (You will need a screwdriver.)
1. Carefully remove all components from the package
and check to ensure nothing is
damaged. If equipment is damaged,
immediately notify the retailer from
where the equipment was purchased.
2. The sand filter should be placed on
solid, level ground, preferably a
concrete slab. Position the sand filter so the Ports and
Control Valve are accessible for operation, servicing
and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter
to be vertically fixed on ground or a certain pedestal
made of wood or concrete before use to prevent the
sand filter from accideutally falling. Fully assembled
sand filter will exceed 18 kg. The mounting holes
should be 8 mm in diameter and spaced 86 mm apart.
Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
Load pool-grade filter sand/Flowclear™
Polysphere.
NOTE: Use only special pool-grade filter sand, free of
all limestone or clay: #20 Silica sand 0.45-0.85 mm,
approximately one 36 kg bag should suffice.
If you do not use the recommended size of filter sand,
filtering performance will be reduced and thesand filter
may damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding
sand, pour some water into the Bottom Tank to
submerse the Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not
included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to
replace 1 kg (2.20 lbs) sand.
7
86 mm
Ф8 mm
Advertenties
Inhoudsopgave
