Inhoudsopgave
Advertenties
• Do not switch on or operate the sand filter with the Control Valve set to
the Closed function or it will seriously damage the sand filter.
• Do not set the Control Valve between two functions, or it will lead to
leaking.
• To avoid water leakage, screw the Port D Cap onto the Control Valve
Port D before operating the filter or circulate function.
Air Release
Press down the control valve handle and wait untill the water flow
from Port D to release the air.
NOTE: It is important to repeat this operation every time you start
the pump after winterizing, maintenance and backwashing the
sand bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the
pump for its first use and to wash the sand.
CAUTION: DO NOT DRY RUN THE SAND FILTER
1. Press down on the Control Valve handle and rotate to the Backwash function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs clear.
3. Switch off the sand filter and set the Control Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This circulates water backwards through
the sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
Switch off the sand filter immediately if water levels near the pool's Inlet and Outlet valves.
1. Now the sand filter is ready for use. Set the Control Valve to the
Filter function.
NOTE: To prevent the risk of electrical shock dry any excess
water from yourself and the sand filter.
IMPORTANT: Before operation, make sure the tank is placed
steadily on its base and connected correctly to the pump.
2. Switch on the sand filter to run it.
NOTE: The sand filter has now started its filtering
cycle. Check that water is returning to the pool
and take note of the filter pressure on Pressure
Gauge. Generally, the recommended sand filter
pressure is less than 0.56 Bar (8.0 PSI) when it
is running.
This procedure removes water from the pool, which you'll need to replace.
12
Backwash
10
15
5
23
0
psi
bar
Rinsing
20
Advertenties
Inhoudsopgave
