Inhoudsopgave
Advertenties
11. Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
12. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equip-
ment fails to work properly. If the problem still persists after working through the list, please contact your nearest ser-
vice workshop.
Fault
Machine does not start.
Machine starts but stops
again.
Machine works with
interruptions (sputtering).
Smoke is generated
Machine does not work at
full power.
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
Possible cause
• Air filter is contaminated.
• Fuel filter is blocked.
• Lack of fuel supply.
• Fault in the fuel line.
• Starting device is faulty.
• Engine stalled.
• Spark plug cap not attached.
• No spark.
• Engine faulty.
• Carburetor faulty
• Blowing/suction pipe is not completely
fitted
Wrong carburetor setting (idle speed).
• Carburetor set up incorrectly.
• Spark plug is sooty.
• On/off switch faulty.
• Wrong fuel mix.
• Carburetor set up incorrectly.
• Air filter is contaminated.
• Carburetor set up incorrectly.
• Collection bag is full
• Collection bag is dirty
• Selector switch in incorrect position
• Device clogged up or blocked by foreign
bodies
Remedy
• Clean/replace the air filter.
• Clean or renew the fuel filter.
• Re-fuel.
• Check the fuel line for kinks or damage.
• Contact the service centre.
• Remove the spark plug, clean and dry it;
then pull the starter rope several times;
re-fix the spark plug.
• Check the correct position of the spark
plug cap.
• Clean the spark plug or replace it, if
applicable. Check the ignition cable for
damage.
• Contact the service centre.
• Contact the service centre.
• Install a two-part blowing/suction pipe
Contact the service centre.
• Contact the service centre.
• Clean the spark plug or replace it.
• Contact the service centre.
• Use two-stroke mixture at a ratio of 40:1.
• Contact the service centre.
• Clean the air filter or replace it.
• Contact the service centre.
• Check the exhaust.
• Empty collection bag
• Clean collection bag
• Set selector switch to the suction symbol
• Remove plug or blockages (see chapter
Cleaning and Maintenance)
GB | 33
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
