EN
SAFETY INSTRUCTIONS (1/2)
Only connect the appliance to an earthed wall socket.
This heater must be used on an AC supply only and the voltage marked
on the heater must correspond to the supply voltage.
Do not switch the appliance on until it properly installed as described in
this manual.
Never use the appliance unsupervised when in use.
If you have to leave even for a short moment please stop the appliance.
Keep out of reach of children and do not allow them to operate this
appliance.
Only use the appliance for domestic purposes and in the way indicated
in these instructions.
From time to time check the cord for damages.
Never use the appliance if the cord or any part of the appliance shows
any signs of damage.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
Make sure the connection cord does not touch any hot surfaces.
Do not use the appliance outdoors
Do not use if you have wet hands.
Never use the appliance on or near hot surfaces.
Never move the appliance by pulling the cord.
Before cleaning the appliance, make sure it is unplugged from the
power and that it is completely cooled.
Do not clean the appliance with abrasive chemicals.
Never use accessories that are not recommended or supplied by the
manufacturer. It could cause danger to the user or damage to the
appliance.
The heater should not be put under the jack directly.
Electric Stove - English manual
3