Inhoudsopgave
Advertenties
d) The battery is now accessible.
e) To replace the battery, remove the old one with a
small flat screwdriver from its plastic support by lifting
the edge slightly (fig. 2 E). Afterwards you can insert a
new battery. Please ensure the correct polarity of the
battery.
Reassembly
a) Insert the front face into the housing of the push-
button and press both firmly together until the housing
parts lock in place. Please make sure that the rubber
gasket sits correctly within the housing.
b) Carefully set the small screw (fig. 1 B) with a small
Phillips screwdriver.
c) Hook the plastic front onto the clip of one side, then
press the other side down until the front completely
locks onto the housing.push button and press both firm-
ly together until the housing parts lock in place.
Mounting the Doorbell/Callbutton
You can mount the Doorbell/Callbutton using the sup-
plied strips of double-sided tape. Take care to adhere it
to a smooth, dry and clean surface.
Important note:
Kindly keep in mind that metal parts and other building
materials may interfere with the transmission of the ra-
dio signal.
As they can be either visible or hidden at the desired
mounting location, you should always carry out a fun-
ctional test at the mounting location before starting the
mounting process, and, if required, choose a different
mounting or installation location if the reception is not
guaranteed.
20 English
Advertenties
Inhoudsopgave
