Inhoudsopgave
Advertenties
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
ADDITIONAL SAFETy FOR ELECTRIC PLANERS
• Ensure all nails, screws etc are removed from the
workpiece before commencing the task. Otherwise,
damage to the blade or planer could occur, causing a
safety hazard.
• If possible, use clamps or a vice to hold your work.
• Handle blades with caution.
• Ensure that the blade installation screws are securely
tightened before operation.
SYMBOLS
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authority or
retailer for recycling advice
Always wear ear, eye and respiratory protection
All manuals and user guides at all-guides.com
• Before using the planer on a workpiece, switch on
• Allow the machine to reach full speed before making
• Operate the planer only when controlled by both
• Ensure the planer is at least 200mm away from your
• Always switch off and allow the cutter to stop before
• Wait until the blades reach full speed before
• Shavings may jam in the chute when cutting damp
• Always switch off and allow the blades to come
• When leaving the machine unattended, disconnect
• When not in use, disconnect from the power source
• Replace all blades at the same time, otherwise the
and allow it to run for a while. Check for vibration or
wobbling that could indicate a badly installed or a
poorly balanced blade.
contact with the workpiece.
hands.
face and body.
setting the planer down. An exposed moving cutter
may engage the surface leading to possible loss of
control and serious injury.
cutting.
wood. Switch off and unplug the power source and
clean out the chips with a stick. WARNING: Never put
your finger into the chip chute.
to a complete standstill before attempting any
adjustments.
from the power source.
and place the front base on a wooden block so that the
blades are not in contact with anything.
resulting imbalance will cause vibration and shorten
the service life of planer and blades.
Conforms to relevant legislation
and safety standards
Do not use before viewing and
understanding the full operating
instructions
Double insulated for additional
protection
Safety Instructions / Symbols
GB
5
Advertenties
Hoofdstukken
Inhoudsopgave
