4. The device may only be opened and/or repaired by a competent
and qualified person. Do not carry our your own repairs as this
could be dangerous! Repairs carried out by unauthorised persons or
changes made to the device could damage the dust/waterproof
capacity of the device and will nullify the guarantee and the
manufacturer's liability.
5. If the electrical cable is damaged, it must be replaced by the
manufacturer, their service department or somebody with similar
qualifications in order to prevent creating a hazard.
Failing to adhere to points 3, 4, 5, could lead to damage, fire and/or
personal injury. They will invalidate the guarantee and the supplier,
importer and/or manufacturer shall not be liable for the consequences.
Description
The CK501R frost shield is an electrical convector heater with a thermostat and is
protected against overheating. The light is illuminated when the frost shield is
switched on. The CK501R frost shield is intended to keep small domestic or similar
spaces frost-free. The heater may only be used when standing (never if it is
mounted or lying down!) and only for the purpose for which it was designed.
1. air outlet grill
2. pilot lamp
3. thermostat dial
4. air inlet grills
5. feet
Location and Connection
Remove all packaging material and keep out of reach of children. After
removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance,
but contact your vendor for inspection or
replacement.
Select a suitable location for the device
taking into account all the aforementioned
warnings in this manual
To use the heater, the feet, delivered separately
in the package, must be mounted on the heater.
The feet should be attached to the base of the
heater using the 4 self-tapping screws. Make sure
they are correctly positioned at the bottom of the heater.
27