Advertenties
▶
If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible and where there is no risk of fire,
at an adequate distance from flammable materials. Allow the battery to cool down. If it is still too hot to touch after an hour, the battery is
faulty. Consult Hilti Service or read the document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning the QR code at the end of these
operating instructions.
Description
1
Product overview
Pressing ring
@
Mounting groove
;
Gripper hook
=
Adapter jaw
%
Adapter jaw leg
&
Pressing jaw/adapter jaw mounting
(
Tool head
)
Piston return switch
+
Servicing and fault indicator
§
Intended use
The product described is a cordless, electro-hydraulic pressing tool.
It is designed for pressing fittings used to connect composite, steel and copper (Cu) pipes.
•
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance, Hilti recommends the batteries
stated in the table at the end of these operating instructions for this product.
•
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these operating instructions.
Possible misuse
•
Do not use this hand-held pressing tool clamped in a fixed position or as a stationary device.
•
Do not use the electro-hydraulic pressing tool in heavy rain or under water.
Items supplied
Pressing tool, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at: www.hilti.group
Status indicators of the Liion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶
If the release button is pressed with a battery inserted in the product, subsequently check that the battery is correctly re-engaged and
secure.
Short-press the release button of the battery to get whichever of the following status indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as the connected product is switched on.
Status
Four (4) LEDs show constantly green
Three (3) LEDs show constantly green
Two (2) LEDs show constantly green
One (1) LED shows constantly green
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
14
Installation opening for accessories
/
Work-area light
:
Control switch
∙
Locking pin
$
Battery
£
Battery release button
|
Battery status indicator
¡
Pressing jaw leg
Q
Pressing die
W
Meaning
State of charge: 100 % to 71 %
State of charge: 70 % to 51 %
State of charge: 50 % to 26 %
State of charge: 25 % to 10 %
State of charge: < 10 %
The Li-ion battery is completely discharged. Recharge the battery.
If the LED again starts quick-flashing after the battery has been
charged, consult Hilti Service.
The Li-ion battery or the product in which it is inserted is overload-
ed, too hot or too cold, or experiencing some other fault.
Bring the product and the battery to the recommended working
temperature and do not overload the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it is inserted are not
compatible. Consult Hilti Service.
2321712
18
*2321712*
Advertenties
