Inhoudsopgave
Advertenties
Always remove flat batteries from the appliance.
If the appliance is not going to be used for long peri-
ods, remove the batteries.
Before inserting the batteries, check that the con-
tacts in the appliance and on the batteries are clean
and, if necessary, clean them.
Always use new batteries of the same type. Never
use old and new batteries together.
Pay attention to the polarity (+/–) when inserting the
batteries.
Two micro batteries, type AAA LR03 1.5 V, are inserted in the remote control.
Replace the batteries if the appliance fails to react to commands from the remote
control properly. Then follow these steps:
Slide the battery compartment flap open by applying a little pressure to the
ribbing.
Remove the two batteries from the battery compartment.
Dispose of the old battery in accordance with legal requirements.
Insert two new micro batteries,
type AAA LR03 1.5 V, into the bat-
tery compartment.
Slide the flap fully back into the
remote control.
. Operation
Plug the mains plug into a suitable socket.
An acoustic signal will sound. The appliance is then in standby mode.
The function buttons on the appliance largely correspond to the func-
tion buttons on the remote control, so they are only named once each.
You can also change the temperature unit using the remote control.
You can set the vertical ventilation direction on the appliance.
.. Switching the appliance on/off
Press the
button to switch on the appliance.
Press the
button again during operation to switch the appliance off.
222
LR03/AAA
Micro
Fig. 14 – Battery compartment
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
